LCR-T3 graphical multi-function tester resistor capacitor + + + SCR + diode + transistor + mos tube inductance
LCD 128x64 LCD display, with backlight , backlight color is generally yellow-green .
9v battery powering stacked . If prolonged power , you can use two 8.4v lithium battery pack consisting of .
- Add boot voltage detection function
- Automatic detection of NPN and PNP transistors , N -channel and P-channel MOSFET, diodes ( including dual diode ) , thyristors , transistors, resistors and capacitors and other components ,
- Automatic test out the pin element and displayed on the LCD
- 4.Can be detected to determine the transistor emitter forward bias voltage of the transistor , MOSFET protection diode and the amplification factor of the base
- Measure the gate threshold voltage and gate capacitance of the MOSFET
- 1602 lcd display uses LCD (12864 LCD with backlight )
- High test speed , valid component test: 2 seconds ( except in the larger capacitor of large capacitance measurement also takes a long time , the measured time of one minute is normal )
- One button operation , power-on test , get a key .
- Power consumption off mode : less than 20 nA of
- Auto power off function to avoid unnecessary waste , saving battery power , improved battery life.
Inductors, capacitors , diodes, dual diode , mos, transistor, SCR , the regulator, LED tube , ESR,
Resistance :0.1 ohm resolution, maximum 50M ohm
Capacitor :25pf -100,000 uf
Inductors : 0.01mh-20H
- Automatic detection of NPN and PNP transistors, n-channel and p-channel MOSFET, diode (including double diode), thyristor, transistor, resistor and capacitor and other components
- Automatic test the pin of a component, and display on the LCD
- Can detect the transistor, MOSFET protection diode amplification coefficient and the base to determine the emitter transistor forward biased voltage
- Measure the gate and gate capacitance of the MOSFET threshold voltage
- Use 12864 liquid crystal display with green backlight